Time Lag Switch - touch activated time lag switches [KH2] : Sparks Direct, Lighting and Electrical Wholesaler

Home > Fire and Security > Energy management > Time Lag Switches > Time Lag Switch - touch activated time lag switches

Click on image to zoom in

enlarge image in popup

Model: KH2

policy (Exceptions and Terms &
Conditions apply. View.)

Time Lag Switch - touch activated time lag switches

Touch activated time lag switches to replace existing light switches.

UK Patented No. 2217933
Touch activated time lag switch
Load Rating at 230VAC: Incandescent / Fluorescent / Compact Fluorescent - 10A
Time Delay: 10 secs - 20 min approx.
The KH2 time lag switches are a quick and effective way to reduce energy consumption for lighting applications. Pressing the button or touch pad brings the lights on; the lights will then switch off automatically after a preset time period has elapsed.
These units do not require a neutral connection, therefore they can be used to replace an existing light switch. The duration of the time delay is set by a thumbwheel on the reverse of the unit.
Time lag switches can be used in two way and intermediate switching arrangements without any extra wiring.

Features:

LOAD: 10A of lighting including incandescent, fluorescent, compact fluorescent, low voltage (switch primary of transformer).
Fluorescent and compact fluorescent fittings with “switch start” ballasts - 10 ballasts maximum.
Power factor correction capacitors must be fitted.
Most fluorescent fittings have power factor correction capacitors fitted. If they are not present the unit may fail to turn off properly or flicker. In this case fit one capacitor per circuit with a minimum value of 1μF for every unit installed. The capacitor should be fitted across switched live and neutral. Note that it is not necessary to fit a capacitor on every fitting. This also applies to fittings controlled with high frequency ballasts and maintained emergency fittings.
Not suitable for switching contactors
Not suitable for SON lighting
Not suitable for heating or ventilation loads.
SUPPLY VOLTAGE 220-240 Volts AC 50 Hz
TIME OUT PERIOD 20 seconds to 20 minutes (approximate)
FIXING METHOD Surface fixing 25mm deep plastic surface mount moulded box.
Flush fixing 25mm steel wall box or 32mm deep cavity wall box.
TERMINAL CAPACITY 1.5mm2
MATERIAL Flame retardant ABS
TYPE Class 2
TEMPERATURE -10°C to 35°C
CONFORMITY EMC-89/336/EEC
LVD-73/23/EEC

VAT: ON / OFF

Your cart is empty.