0-1000W In-line LED Dimmer Module with Press Switch, Remote Dimming Pack for LED, LV, CFL, and Tungsten

This is a Zano Controls ZBARLED remote dimming pack compatible with all the dimmable lamps, including LED for flicker-free, smooth, and silent results. It is simple to install and it fits through a 62mm diameter hole in the ceiling and is easily connected using the existing twin and earth wiring.

This Zano Controls ZBARLED will dim LED, CFL and Tungsten. The advanced technology used to control the waveform results in flicker free dimming of leading and trailing edge dimmable lamps & drivers. It is designed to fit both new and existing installations.

The product has built in thermal protection and will automatically reset when cool. It also has built in short circuit and overload protection if the unit detects a fault it will automatically shut down and will require the supply being switched off and the fault rectifying before switching on the supply.

Control of the unit can be made via a Zano rotary controller, where up to 32 rotary controllers can be connected in parallel to one ZBARLED. Alternatively, control can be made via two different types of push to make retractive switches; the first type being push to make only, the second type being a rocker push up and down. Each controller or switch may be connected on existing twin and earth wiring.

Features

• Flicker Free & Silent
• Up to 32 Rotary Controllers (Zano rotary controller available separately)
• No Commissioning
• No Rewiring Required
• Easy To Install
• LV, CFL & Tungsten
• Short Circuit Protection
• Protects LED Lamp Life
• Made In The U.K.
• Technical Helpline
• Fit & Forget.
• Will fit through min Hole 62 mm ø
• Compatible with retractive push to make switches

Technical Specs

• Compatibility with LED: yes, compatible with good quality dimmable LED lamps.
• Compatibility with Halogen: yes, compatible with dimmable halogen lamps.
• Compatibility with Low Voltage: yes, compatible with dimmable low voltage lamps.
• Dimming Operation: Rotary Controller, Momentary Switch, Push To Make, Push Up / Down
• Soft Start: Yes
• Short Circuit Protection: Yes
• Overload Protection: Yes
• Thermal Protection: Yes
• Minimum Level Pre Set: Yes
• Operation Noise: -110 dBA
• Power Consumption: 2 Watts
• Supply Voltage: 230 V
• Frequency Range: 50 HZ
• Max Operating Temp: 50º C
• Humidity Range: 95% Non Condensing
• Max Ambient Temp: 35º C
• Min Ambient Temp: -5º C
• Max Load: 1000W
• Min Load: 0W
• Termination: Pre Terminated 8 core 0.75 flex
• Protection: IP40 rated
• Country Of Origin: U.K.

Installation

• Note: Installation must be carried out by a qualified electrician.
• This product must be installed in accordance with the relevant wiring regulations.
• Switch off mains supply
• Decide on a suitable location for the dimmer pack with adequate ventilation and ensure the dimmer is mounted away from insulation
• If multiple units are mounted within close proximity, ensure a 15mm gap between units
• Commence connections as per appropriate wiring diagrams and in accordance with the relevant wiring regulations