1 Gang 2 Way 400W Dimmer on Transparent Screwless Flat Plate and Metal Knob (Leading Edge)

This is the Hamilton Litestat 1 Gang 400W 2 Way Single Dimmer (part of the Perception CFX range) in a Transparent Plate with Satin Chrome Rocker. Clear perspex plate with metal knob. Concealed Fixing Leading Edge Push On/Off Resistive Dimmers on Transparent Plates

Please note: This is a special order item and will be Non Returnable.

Note: when ordering this device, please select the finish of the dimmer - it comes standard in Satin Chrome, see the finishes available in the list above

Perception Clear Push On/Off Dimmer 1 gang 2 way 40W (min) - 400W (max)

• Rocker Switch: standard in Satin Chrome (PC 1X40 SC), also available in: Bright Chrome (PC 1X40 BC), Polished Brass (PC 1X40 PB), Satin Brass (PC 1X40 SB), Antique Brass (PC 1X40 AB), and Black Nickel (PC 1X40 BK).
• Device type: Dimmer (resistive - see note below)
• Plate material: Plastic
• Size (single): height 86mm, width 86mm, depth 4.2mm
• Box fixing hole centres: 60.3mm
• Minimum wall box depth: 35mm
• Wattage: 400W
• Current rating: 1.66 Amp
• Voltage: 220/250V AC
• Max load: 400W resistive
• Mains Frequency: 50Hz
• IP rating: IP2XD
• Switched Poles: Single
• Terminal Capacity 1: 2 x 1mm2
• Terminal Capacity 2: 2 x 1.5mm2
• Earth Terminal Capacity 1: 5 x 1mm2
• Earth Terminal Capacity 2: 4 x 1.5mm2
• Earth Terminal Capacity 3: 3 x 2.5mm2
• Earth Terminal Capacity 4: 1 x 4mm2 Multi-Strand
• Earth Terminal Capacity 5: 1 x 6mm2
• Product Class 1: Face plate must be earthed
• Ambient Operating Temperature: -5° to +40°C
• Recommended Location: indoor use only
• Max installation Altitude: 2000m
• BS EN ISO Standard: BS EN 60669-2-1
  * Denotes LEADING EDGE TECHNOLOGY DIMMERS. Resistive dimmers are suitable for control of incandescent lamps. When dimming GU10 type mains halogen or linear halogen lamps the dimmers need to be derated by 25%. When used for dimming low voltage electronic h
• Patents and Trademarks: CFX is a Registered Trade Mark No 239866.

Note: Tungsten filament GU10 lamps must be branded and with a fused base. When using mains voltage halogen lamps - dimmers should be de-rated by 25%. 

Please note: this item comes with an invisible / clear perspex plate and a metal plate (a stencil); you can install the metal plate and put the wallpaper on top of it, using it as a stencil to cut out your wallpaper; alternatively, you can paint the piece of paper provided (which fits into the plate) with the colour of the wall and mount it on the metal plate under the clear plastic plate.