2 Gang 2 Way 400W Dimmer on Transparent Screwless Flat Plate and Metal Knob (max. 300W per gang)

This is the Hamilton Litestat 2 Gang 2 way double dimmer (40W - 400W), part of the Perception CFX range, in a Transparent Plate with Metal Rocker. Clear perspex plate with metal dimmer switch. Max. 300W per gang.

Please note: This is a special order item and will be Non Returnable.

Note: when ordering this device, please specify the finish of the rocker (it comes in Satin Chrome as standard, but can be ordered in different finishes - see the list above).

Perception Clear Push On/Off Dimmer 2 gang 2 way 400W max 40W min

• Rocker Switch: standard in Satin Chrome (PC 2X40 SC), also available in: Bright Chrome (PC 2X40 BC), Polished Brass (PC 2X40 PB), Satin Brass (PC 2X40 SB), Antique Brass (PC 2X40 AB), and Black Nickel (PC 2X40 BK). No trim / insert.
• Insert type: Dimmer (resistive - see note below)
• Plate material: Clear Plastic
• Size (single) height: 86mm, width 86mm, depth 4.2mm
• Box fixing hole centres: 60.3mm
• Minimum wall box depth: 35mm
• Wattage: max. 300W per gang
• Current rating: 1.66 Amps per gang
• Voltage: 220/250V AC
• Max load: 400W resistive per gang
• Mains Frequency: 50Hz
• IP rating: IP2XD
• Switched Poles: Single
• Terminal Capacity 1: 2 x 1mm2
• Terminal Capacity 2: 2 x 1.5mm2
• Earth Terminal Capacity 1: 5 x 1mm2
• Earth Terminal Capacity 2: 4 x 1.5mm2
• Earth Terminal Capacity 3: 3 x 2.5mm2
• Earth Terminal Capacity 4: 1 x 4mm2 Multi-Strand
• Earth Terminal Capacity 5: 1 x 6mm2
• Product Class 1: Face plate must be earthed
• Ambient Operating Temperature: -5° to +40°C
• Recommended Location: indoor use only
• Max installation Altitude: 2000m
• BS EN ISO Standard BS EN 60669-2-1
• Patents and Trademarks CFX is a Registered Trade Mark No 239866

Additional Notes: Resistive Dimmer denotes LEADING EDGE TECHNOLOGY DIMMERS. Resistive dimmers are suitable for control of incandescent lamps. When dimming GU10 type mains halogen or linear halogen lamps the dimmers need to be derated by 25%. When used for dimming low voltage electronic 

Please note: this item comes with an invisible / clear perspex plate and a metal plate (a stencil); you can install the metal plate and put the wallpaper on top of it, using it as a stencil to cut out your wallpaper; alternatively, you can paint the piece of paper provided (which fits into the plate) with the colour of the wall and mount it on the metal plate under the clear plastic plate.