230V input 11.5V Output 10-150VA Dimmable Electronic Transformer for Low Voltage Lighting 10-150W Loads, Mode ET-150-PL-230-RD

This is the Mode Lighting ET-150-PL-230-RD - a 10-150 VA Dimmable Electronic Transformer for Low Voltage Lighting for 10-150W Loads. It has a 230/240V input and 11.5V output. 

Note: the image is for informative purposes only (to see the size and aspect of the transformer); this is a 12V transformer. 

Mode Dimmable Electronic Transformer 10-150W - Features

• Dimmable with ALL types of domestic and hard-fired dimmer.
• Self resetting, short circuit and overload protection.
• Complies with EC EMC and Low Voltage Directives.
• Complies with EMC Emission Standard EN 55015.
• Complies with EMC Immunity Standard EN 61547.
• Energy efficient, ensures cool operating temperature.
• Terminal covers and cable clamps.
• Suitable for 10W to 150W loads.
• Flame retardant moulded enclosure, UL94-V0.
• Lightweight and compact size, only 255 grams.
• Mode products are guaranteed for two years.
• Low audible noise throughout the dimming range.

Mode Lighting 10-150VA Dimmable Electronic Transformer - Specs

• Product code: Mode Lighting ET-150-PL-230-RD
• Voltage: 230/240V input, 11.5V RMS nominal output
• Input current: 0.75A max
• Output current: 13A max
• Input power: 0.99
• Output power: 10-150VA
• Dimensions: 173mm length, 33mm height, 54mm width
• Input frequency: 50/60Hz
• Output frequency: 40 KHz
• Input terminals: 2xL 2xN
• Output terminals: 3 x 0V, 3 x 12V
• Temperature case rise 40 degs max, ambient 40 degs, case 80 degs max
• Protection: short circuit (auto-reset), overload (auto-reset), thermal (auto-regulating)
• Fusing: fusible PCB link primary, no secondary fuse required
• Standards: EN 61347-2-2 (safety), EN 55015 (EMC emission), EN 61047 (performance), EN 61000-3-2 & EN 61000-3-3 (harmonics fluctuations), EN 61547 (EMC immunity)
• Regulation: better than 5%
• Weight: 255g
• Efficiency: typical 96%

Dimmable Transformer - general details

• Installation should be in accordance with the relevant National Wiring Regulations and other applicable Regulations. 
• Compliance to the EC EMC and Low Voltage Directives may be invalidated if not used or installed according to the published specification.
• Electronic Transformers operate at high frequencies. The output voltage cannot be measured on a standard voltmeter.
• The output leads should not be separated by more than 10mm and should be kept to a minimum length to achieve optimum regulation and EMC suppression.
• Electronic Transformers are not recommended for parallel rod or tensioned wire lighting systems. Observe dimmer manufacturer's recommended load ratings. 
• Electronic Transformers should be located in well ventilated areas and should not be covered or enclosed by insulating materials.