300x970mm Mirror Demister Pad 54W Self-adhesive and Double Insulated for Mist-free Mirror, BN Thermic MD3-97

Model No. HMP2 by: BN Thermic.
£92.41 Ex. VAT
This item requires:

Free delivery
(over £100 +VAT, applies to zone A and B only, £6 +VAT otherwise)

Usually 3-5 days

Click & Collect

Order online & collect in store

Our customers love us - read their reviews

Wishlist Ask a question Compare

This is the BN Thermic MD3-97, a 300x970mm Mirror Demister Pad 54W for Mist-free Mirror, Self-adhesive and Double Insulated. It provides a mist-free mirror and is 100% effective in a little over 2 minutes, with a very low energy consumption. You can simply integrate it into the lighting circuit, making sure that they are not left running. 

Mirror Demister Pad for Mist-free Mirror - Features

  • It protects an area of approx. 20% larger than the pad itself.
  • It is double-insulated and completely sealed for total safety. 
  • It has a very low energy consumption
  • It can simply be integrated into the lighting circuit, making sure that it is not left running.
  • It is also called: heated demister pads, demister pads, heated mirror demister pad, or mirror demister pad.
  • It is mains voltage: 230V supply. 
  • It comes with a 1m long power lead.
  • It has a peel-off adhesive backing. 
  • Very thin: it is less than 1mm thick
  • A mirror demister pad's typical running cost is 5p per week

300x970mm Mirror Demister Pad 54W for Mist-free Mirror - Specs

  • Wattage: 54W
  • Dimensions: 970mm length x 300mm width x 1mm thickness
  • Voltage: 230V
  • Nominal power rating: 200W/m2
  • Double insulated 
  • IP rating: IP44 rated

Mirror Demister Pad - Instructions and installation

  • Remember: a pad will demist an area approx. 20% larger than its actual area
  • It can be connected to a switched lighting circuit, so that it is activated when the light is turned ON. It can also be wired to a separate ON/OFF switch, but this switch must be suitable for an area in which it is used and placed in a position that it cannot be touched by a person standing or sitting in the bath/shower. 
  • A double pole RCD needs to be installed for all fixed current using appliances in zones 2 and 3 in a bathroom. 
  • Several pads may be fitted to cover the whole area, however, never cut any pads - always use pads that are slightly smaller than the mirror. If several pads are fitted to a single mirror, they should be wired in parallel. Do not overlap the pads, as this could cause hotspots and possible damage to the mirror. Also, make sure that the power supply is sufficient to take the total load of all the pads. 
  • The mirror demister must not be cut or pierced as this will damage the insulation and render it unsafe; once installed, the mirror demister must not be accessible. 

Please check the full instructions and specifications for advice on installing this mirror demister pad. 


Follow us for exclusive offers and tips about lighting, switches and sockets

Get in touch

Telephone 020 7263 8007

Fax 020 7272 3007

Sparks Electrical Wholesalers Ltd, 659-661 Holloway Road, Archway, London, N19 5SE, United Kingdom
Registered in England. Company No. 2238028. VAT Reg No: GB 505 6899 17. Copyright © 2003-2021 SparksDirect

Award Winning Ecommerce from Cyber-Duck